Variation 5 ribbed sheet

Ribbed panels

Product Information:

Image Project information - 1
Image Project information - 2

Fastener:

  • The specifications of the fasteners must comply with the recommendations of the SNFA professional regulations. The fasteners are placed at the bottom of the rib every 3 ribs maximum.
  • On wooden beams: Anchoring length 40 mm Pointed end self-tapping screw Ø ￸ 6.3x50 mm minimum
  • On metal rails: Minimum thickness 15/10th Self-tapping screw Ø ￸ 6.3x35 mm minimum depending on the thickness of the drilling

Installation:

On transverse wooden or metal rails the spacing of which varies according to the specifications of the product and the climatic loads. Support width on wooden rails: 60 mm, metal: 40 mm.

MOUNTING ACCESSORIES: see assembly sheet

SPAN TABLE: upon request according to the pitches

HALF-ROUND RIB

  • Effective width: variable according to the number of pitches
  • Maximum length: 3000 mm
  • Minimum pitch: 9 to 20 mm
  • Wave height: 5 to 10 mm

Key features:

  • Effective width: variable according to the number of pitches
  • Maximum length: 6000 mm
  • Minimum pitch: 510 mm
  • Wave height: 56 mm

Profile:

  • Effective width: variable according to the number of pitches
  • Maximum length: 3000 mm
  • Minimum pitch: 9 to 20 mm
  • Wave height: 5 to 10 mm

Use:

  • The range of ribbed panels is a selection of decorative cladding produced by micro-folding, which can be used for covering e façades, roof cladding or interior cladding.
  • This system is intended to be implemented on façades or designer cladding.

Perforations:

More than 300 possible perforations:

  • Round
  • Square
  • Elongated
  • All surfaces
  • By zone
  • Ribbed
  • Ultramarine Sensation

Anodising:

  • Clear Anodising
  • Gold
  • Bronze
  • Colouring
  • Class 15 or 20
  • Post anodised after parts manufacturing

Metal:

  • Aluminium
  • Galvanized steel
  • Stainless steel
  • Copper

Lacquering:

  • All RAL colours
  • Polyester and PVDF quality
  • Pre-coating on the roll
  • Electrostatic powder coating finish
Technical datasheet: